CL-FSP Configuration File Generator V2-04 · 2026-10-08

Define Lighting Fixture
Name to be shown on the CL-FSP screen, max 13 characters, reduce if can’t be shown on screen due to too many wide characters.
Import DMX Profile from GDTF File
Optional: load a fixture's .gdtf file to read its official DMX channel list, then apply chosen channels to the faders below (Name, DMX Channel and Resolution). The GDTF file is read entirely in your browser and is not uploaded anywhere.
...or drag and drop a .gdtf file here.
This fills in each fader's Name, DMX Channel and Resolution below (channel numbers are relative to this fixture's start address, same as the Fixture Start Channel field further down). Review and adjust the faders below afterwards, including Fader Enabled, before creating the configuration file.
Channels whose fine byte comes before the coarse byte are mapped to 16bitLH. Channels marked "unsupported" in the dropdowns use a 16bit coarse/fine pair at non-adjacent DMX addresses, which this tool can't map to a single fader - those are greyed out and can't be selected.
Fader A
Name to be shown on the CL-FSP screen, max 10 characters, reduce if can’t be shown on screen due to too many wide characters.
Assuming fixture is set to start address 1.
Percentage of full level, 0-100%.
Percentage of full level, 0-100%. Can be set lower than Fader Min Level to reverse the fader's operation.
What happens if the fader is disconnected.
Fader B
Name to be shown on the CL-FSP screen, max 10 characters, reduce if can’t be shown on screen due to too many wide characters.
Assuming fixture is set to start address 1.
Percentage of full level, 0-100%.
Percentage of full level, 0-100%. Can be set lower than Fader Min Level to reverse the fader's operation.
What happens if the fader is disconnected.
Fader C
Name to be shown on the CL-FSP screen, max 10 characters, reduce if can’t be shown on screen due to too many wide characters.
Assuming fixture is set to start address 1.
Percentage of full level, 0-100%.
Percentage of full level, 0-100%. Can be set lower than Fader Min Level to reverse the fader's operation.
What happens if the fader is disconnected.
Fader D
Name to be shown on the CL-FSP screen, max 10 characters, reduce if can’t be shown on screen due to too many wide characters.
Assuming fixture is set to start address 1.
Percentage of full level, 0-100%.
Percentage of full level, 0-100%. Can be set lower than Fader Min Level to reverse the fader's operation.
What happens if the fader is disconnected.
Create CL-FSP Configuration File
The DMX start address the fixture is set to.
Fader A
Override the Fader Min Level setting with DMX input. 8bit or 16bit will be as set for Resolution.
Override the Fader Max Level setting with DMX input. 8bit or 16bit will be as set for Resolution.
Fader B
Override the Fader Min Level setting with DMX input. 8bit or 16bit will be as set for Resolution.
Override the Fader Max Level setting with DMX input. 8bit or 16bit will be as set for Resolution.
Fader C
Override the Fader Min Level setting with DMX input. 8bit or 16bit will be as set for Resolution.
Override the Fader Max Level setting with DMX input. 8bit or 16bit will be as set for Resolution.
Fader D
Override the Fader Min Level setting with DMX input. 8bit or 16bit will be as set for Resolution.
Override the Fader Max Level setting with DMX input. 8bit or 16bit will be as set for Resolution.